MFG 160 – Lightweight foam gun
Cost-effective gun for laying the polyurethane foams. Suitable for use in craft and everyday life.
- Lightweight design
- Precise dosing through adjusting screw
- Comfortable trigger
- Detachable design for better cleaning
Before starting work screw the adjustment screw so that it blocks the trigger. Then screw the prior shaken can with foam on the adapter. Be careful not to exercise too much force when tightening the can. Unscrew the adjustment screw 2-3 turnover and point the nozzle at an empty container for disposal. Extruding a small amount of foam, while adjusting screw flow. Hold the can always upside down.
In the termination of work for a relatively short time, screw the adjustment screw so as to lock the trigger and seal the needle to the dosing nozzle and leave the can screwed to the gun.
When replacing an empty can with a new one, turn adjustment screw so as to blocks the trigger, unscrew the empty can and immediately screw the new in its place.
When stop operation for a longer period of time, before removing the can from the gun, screw the adjustment screw so as to blocks the trigger of the gun. Then unscrew the can from the adapter and immediately clean the adapter with cleaner for polyurethane foam Great Stuff Pro Gun Cleaner, using the nozzle for hand operating attached to cleaner can. Then remove the tip for handiwork from the nozzle of cleaner can and screw the cleaner can on the gun adapter. Point the gun at the empty vessel for waste unscrew a 4-5 turnover and press the trigger repeatedly to push the required amount of cleaner. Note that in the beginning will be extruded a certain amount of foam. Do not attempt to use this foam in place to work. The gun is completely cleaned when through the nozzle begins to coming out clear cleaner. Screw the adjustment screw completely and stow the gun.
The design of the gun allows full disassembling when needed cleaning of particles that interfere with normal operation. Use only suitable tools for disassembling to protect parts from damage. Give special attention to disassembling, cleaning and installation of seals, ball valve and the end of needle sealed the nozzle. These details are very sensitive to rough mechanical impact and any surface damage will make them unusable. Damaged seals will allow the foam in the gun to contact with atmospheric moisture, which will lead to its cure in the tool. Already solidified in a narrow closed volume foam could not be removed. Well maintained gun can be used for many years.
- Do not throw or load with weights the gun. This will lead to distortions in the structure and its irreversible damage.
- Keep the gun on clean and dry place.
- Never and under any circumstances do not point the gun at a person, animal, or other living organisms. This can lead to serious consequences for their health and life!
| Construction | aluminum body, adapter and trigger, steel tube and needle, brass screw head of the needle and nozzle, plastic handle |
| Color | green handle |
